1 Topic by violetdream (edited by violetdream 2011-05-30 08:25:25)

  • Registered: 2009-12-16
  • Posts: 55

Topic: partition issue with new Chumby OE build, won't boot

I downloaded the new files for OE, which now unpack into "meta-chumby" instead of just chumby, and seem to have changed in other ways.

When I put the card into my chumby, the screen stays blank. I remember that when I did a bad flash of just the file system I also got this, so I looked at the partitions more closely. It looks like now it doesn't have those dual partitions which is what allows it to boot.

This is a silvermoon device, the 8 inch Infocast. Is there a setting where I can turn that back on?

Edit: I just pulled up the older version of chumby.inc that I had. You can see it here:

https://github.com/zdw/chumby-oe/blob/m … chumby.inc

Note that it does a lot more than what's in the meta-chumby zip, which essentially just does the last part.

  • Registered: 2009-12-16
  • Posts: 55

Re: partition issue with new Chumby OE build, won't boot

Nevermind, I didn't follow all the steps for the new meta-chumby OE and was confused that I didn't get mirrored filesystems - the difference now is that I can have things boot but I don't see the "Insignia.." logo on the beginning. I'm assuming these new images are normal.