• Registered: 2007-11-09
  • Posts: 59

Topic: I2C port

Hi
There are many I2C sensors available today, chumby has two Test Points with I2C signals, but this TPs are very small and is very difficult attach any wire to them..  Is Possible for future development change this TPs to another one, similar to the Serial port? 


Carlos

  • Registered: 2007-10-17
  • Posts: 3

Re: I2C port

I second the motion. We need easier hardware access to the I2C ports!

  • From: Singapore
  • Registered: 2006-08-26
  • Posts: 188

Re: I2C port

I'll keep that in mind. I thought the test points were big enough to solder but maybe I spend too much time soldering TSSOPs by hand :-)

They may just be larger diameter pads, instead of through-holes though. The routing layers in that area are precious.

7BAA 2E53 01C1 DCFF 497B  E7F0 9699 A303 78F0 D9B9

bunnie's Website

  • Registered: 2009-01-27
  • Posts: 1

Re: I2C port

Is this done for the 2009 version? I'm considering ordering one... to test with some i2c devices...