Topic: OE Console output

I'm trying many images which after the initial Angstrom loading screen (or after nothing at all) go blank. I think these images are made for the Hacker board which has a serial output. How do I force the console output onto the chumby's screen instead?

Re: OE Console output

smile I'm confused, do you have a Chumby or an Infocast 8? smile

Re: OE Console output

Uh sorry, I have an infocast 8 and a few 3.5s. I just call them Chumbies sometimes smile I'm working on the Insignia 8. Apologies if the instructions are different..

Re: OE Console output

http://joe.blog.freemansoft.com/2011/01 … or-on.html
^^^ Serial console

Look for GuyC's posts, a fresh GIT of OE doesn't seem to quite work.
We're using the same OE as the one in the AMI/VM images provided by Bunnie to get anything to boot...

Re: OE Console output

I wouldn't play with OE without the serial console.  How did you expect set it up/tweak it until you had all the setup scripts right?

Re: OE Console output

Madox wrote:

http://joe.blog.freemansoft.com/2011/01 … or-on.html
^^^ Serial console

Look for GuyC's posts, a fresh GIT of OE doesn't seem to quite work.
We're using the same OE as the one in the AMI/VM images provided by Bunnie to get anything to boot...

WELL that would explain why NOTHING boots!! Aggr. I will pull that one and try again.

Re: OE Console output

The screen is big enough that I can debug with a keyboard in the console, although it is annoying.

Where would I get this special OE?

Re: OE Console output

Nevermind, found it. The relevant posts addressing this:

http://forum.chumby.com/viewtopic.php?id=6679

The Image:
http://forum.chumby.com/viewtopic.php?pid=36533#p36533