Topic: Compiling new modules and kernel source for Infocast Insignia 8"
I need to compile a new module for the Infocast Insignia 8"
I'm assuming that the best way to do that is to cross-compile via a toolchain on a faster host using the original kernel source.
My problem is that on the various chumby sites I found several different kernel sources but it was not clear which one is the right one for the Infocast Insignia 8"
Note that 'uname -a' gives:
Linux chumby-18-19-09 2.6.28-M2.1.8.12 #1 Thu Dec 9 13:04:27 PST 2010 armv5tejl GNU/Linux
So any suggestions where I can find the corresponding kernel source?
Note: I am using a toolchain from codesourcery which I had previously used successfully on various plugcomputers. Specifically,
http://www.codesourcery.com/sgpp/lite/a … nu.tar.bz2
My make command is:
make ARCH=arm CROSS_COMPILE=../sourcery/arm-2010q1/bin/arm-none-eabi-
Should this all work ok or do I need a special chumby-specific cross compiler?
Thanks