Topic: Hurrah for skip/unskip .. BUT ..
Thanks a bunch for the skip/unskip function .. waited desperately for that.
But ... the button is really small .. so I have to get back to another complaint I had earlier. When I accidentaly miss one of those buttons (dark/skip) .. which happens all the time .. I don't even get back to the control panel .. but my widget starts - I REALLY HATE THAT! I don't want anything to leave night mode except the top button.
Please make night mode so that the screen only reacts to "dark" and "skip/unskip" .. NOTHING else. Dark mode should not be left by tapping on the screen in any manner. And still the widget fires up every time I miss the buttons by pixels .. this is soooo stupid .. I had hoped that this would be gone with the update but it isn't. So I have to stop the widget in half sleep .. get back to the control panel and am awake before I managed to switch back to night. *ggrrrrrrr*
My dream workflow starting from dark mode:
tap on screen goes to night mode -> senstivity in night mode only "dark" and "skip/unskip" -> Top button leaves night or dark mode and shows control panel -> timer of about 15 seconds should run befor widgets start running -> when widget is running top button brings you back to control panel (timer again)
That would be usable and convenient!
If it was up to me I'd even manage without any widgets so I'd only need night mode and the control panel.
If there's any way to facilitate this PLEASE let me know.
Again .. I am grateful for skip/unskip but only implementing that is like stopping half way.