1 Topic by LloydM (edited by LloydM 2008-03-19 12:27:56)

  • From: Lomita, CA
  • Registered: 2008-03-06
  • Posts: 42

Topic: alarm not running channel from start

Say I set my alarm to switch to channel X, which normally cycles through a series of widgets. If before the alarm I had pinned one of channel X's widgets, that widget remains up after the alarm. On the Control Panel though, the widget no longer shows as pinned.

Is this the intended behavior? I'd like the alarm to always start the channel from the beginning, even if the channel was "frozen" partway through before the alarm went off.

-LloydM

"It's Chumbological!"
  • Duane
  • Duane
  • Blue Octy
  • Offline
  • From: San Diego, CA
  • Registered: 2006-08-24
  • Posts: 8,202

Re: alarm not running channel from start

I'll look into that - I believe at the moment that changing to the same channel is short-circuited to some degree.

Duane's Website

  • From: Lomita, CA
  • Registered: 2008-03-06
  • Posts: 42

Re: alarm not running channel from start

Duane -

Thanks. This also happens if the Chumby is on the last widget in my Channel X sequence, which is set to "Forever," before the alarm.

-LloydM

"It's Chumbological!"