1 Topic by bfaber (edited by bfaber 2008-04-08 08:15:18)

  • From: Beaverton, OR
  • Registered: 2008-04-08
  • Posts: 6

Topic: Warranty/hardware/wireless failure question...

So I have a new Chumby.. that when powered up cold..  will seem to connect to my apple airport extreme ok using WPA2 & a manual IP address..

After 10-15 minutes or so.. boom, the connection seems to drop, nothing updates on the screen, and if I go back to the control panel & try reconnecting, it doesn't see any wireless in the area..  (It not only doesn't see my router, it doesn't see ANYTHING in the area).

This seems consistent..  give it 15-30 minutes.. boom, dead.  Even power-cycling it at this point often won't work....

Is this just a bad unit, or is the software problematic?  Any suggestions?

(added:  as somebody noted.. yes, my screen is quite warm after running a while)

bfaber's Website

  • Registered: 2008-05-04
  • Posts: 2

Re: Warranty/hardware/wireless failure question...

I am having a similar problem with mine after being online a few minutes the screen is warm and the wifi drops out until i unplug it and wait 20-30 minutes i'm 15' from the router

  • Duane
  • Duane
  • Blue Octy
  • Offline
  • From: San Diego, CA
  • Registered: 2006-08-24
  • Posts: 8,209

Re: Warranty/hardware/wireless failure question...

Please contact Customer Support.

Duane's Website