Topic: Nekkid Chumby Pr0n
So I received my [used] Chumby day before yesterday. It's so cute it was hard to tear it down - I enjoyed it stock for 24hrs.
The software isn't the only place there are easter-eggs. Bunnie - if you're reading this - love you and the console port. [smooch] And the "secrets" were appreciated too. More on the adapter board...
The device is a heck of a deal. There are a few top-shelf components there, and it's certainly not built as a high-volume/low-cost consumer device. IMHO, more attention was paid to layout and matched component selection than to final BOM cost. Refreshingly rare. The 3v Ref and GND pins are a nice touch too. They give me a handy reference voltage for the TTL->232 level shifter.
So I went ahead and stuffed the console and JTAG ports, and put it back together. Look at that - it's still working!
So hey - nice job guys! Kudos! I can already tell though that I'm going to need a couple more of these... I've got this ten inch touchscreen here that I was going to toss on an old GX1 I have laying around, but gosh it'd look nice [with a new driver] on the Chumby hardware.
Note: Nixie clock shown is a widget by myridom
I Void Warranties (tm)