Topic: interfacing i2c with Chumby One?
I'm contemplating using a Chumby One to control some i2c BlinkM smart LEDs (http://thingm.com/products/blinkm). I have code written to run on a gumstix, but this looks like it could be a much slicker way to do it with the added perks of all the sweet stuff Chumby can already do. Is there any way to get information on how to accomplish this? I've seen some posts with people discussing i2c to some extent, but since I haven't bought a chumby yet it's a bit hard to look into this myself. Specifically how do you physically tie into the i2c bus? Are there any i2c addresses that are reserved for Chumby use only? Has anyone had any success with writing widgets to access i2c? If this will work I plan to buy some ASAP! Thanks!