Yes, I to saw the update message and hit update Now. I completed fine with no errors.

Same levels HWN10.6 SW 1.0.7 FW 1.0.3454 and the Control Panel of 2.8.72

OMG, if this is what I think it is, I will be so stoked!

I just did an update on one of my C1's. And now I have the same very bad problems on it that I have on my InfoCast 3.5: I can no longer run my circa-med.swf off of either my uploaded swf on chumby.com nor from my USB drive. Who do I need to contact to fix this very serious problem?

*DUAAAANE ARE YOU INSANE ??*

You have released this update without fixing the wrong-chumby-id-bug ???
You knew about this bug since a couple of days !!!
Are you aware of the fact that all youstreams-users will lose all their youstreams-radio-stations and podcasts ??
Are you aware of the fact that all SearchTube-users will lose all their favorites ??
Are you aware that other apps also use the id , and now will face numerous problems ?

you´re right, Ratzfatz. All the stations in youstreams are gone. what a shame:-(
any idea how to solve it without typing in each link once again?

I'm looking into this - it was supposed to have been fixed in CP 2.8.72.

There's something going on - I'm looking into it now.

OK, I found it- one of the fields that YouStreams was using was not properly restored to the old method.

I'll see if I can expedite the update.

RatFatz - can you confirm that you're using the "_chumby_chumby_id" field in your widget?

hi,
i already lost all my favorites in searchtube and my radiostations in youstreams with the new cp.

is there anything i can do at the moment to fix that?

the new cp finally comes with a working radio, though seek funktion could be more sensitive and preset is still buggy (as described somewhere above).

manual tuning is a mess, for frequency will not automaticly in/decrease if i keep my finger on the buttons.

after update chumby did some uninspired reboots when using searchtube.

i also ran into the infamous "activate your chumby"- bug which is really annoying.

kabatronix

I don't think you can disable the Skip Next Alarm, but here is a way you can work around it.
Add another alarm a few minutes before your wake up alarm, but make it silent. You could have it switching to the channel that you would normally want to come on with your main alarm. This alarm will be displayed overnight as your next alarm, with the option to skip it. Thus if you accidentally hit 'Skip' during the night it will be this alarm that is skipped and your main alarm will be untouched and work as normal. The only risk is that you might skip the main alarm as well, but since this will only be possible in the few minutes between the silent alarm and the main alarm, the risk is very small.

There is another nasty bug after the update regarding the "chumby_set_volume"-command on a Chumby One.
Without a parameter, the command should return the current volume 0..100. With parameter (0..100) it should set the volume to that value. YouStreams uses this command to display a volume slider that can be used to set the volume (useful on a chumby classic), but also reacts to turning the volume knob on the side of the chumby one.
The problem now is that when you use the knob to set a volume of, e.g., 60, the command returns the correct value 60. But if you use the command to set the volume to this value (which happens when the volume-slider is used instead of the knob)

chumby_set_volume 60

, the chumby gets very silent, i.e. the actual volume is set to a much lower value than 60.
Nevertheless, if you query afterwards, using the command without parameters, it'll return 60.
I should add, that this bug doesn't get fixed by the controlpanel 2.8.73, Duane.