1 (edited by cld 2014-07-02 07:33:44)

Topic: Unable to proceed past the 'Activate your device' screen

I am unable to proceed past the 'Activate your device' screen on my Infocast 8 that is flashed with Chumby. None of the touchscreen buttons ('Later' & 'Next') on this page are active.

I have created an account.

Do you have suggestions?

2 (edited by cld 2014-07-02 08:09:26)

Re: Unable to proceed past the 'Activate your device' screen

SOLVED: Boot device into 'Special Options', follow the instructions to calibrate and then restart device.

I used the following steps:
With the device turned off, insert a USB drive into one of the USB slots on the device.
Once the USB drive is in place, press and hold your finger against the screen and turn the power on.
Leave your finger on the screen while the device powers up. Once you see the 'Special Options' screen loading you can remove/lift your finger off the screen.
You will be asked to calibrate your device, after which you will be taken to the “Special Options” screen.
Restart your device and remove USB drive.

Re: Unable to proceed past the 'Activate your device' screen

Thanks for posting your solution!

Cleaning up any loose bits and bytes.